Siemens SINUMERIK 840D sl Commissioning Manual page 48

7 Machine Data
7.2 Display machine data for ShopTurn
9429
MD number
Standard value: 200
Change becomes effective after: POWER ON
Data type: WORD
Significance:
9450
MD number
Standard value: 0.999
Change becomes effective after: IMMEDIATELY
Data type: DOUBLE
Significance:
9451
MD number
Standard value: 0.999
Change becomes effective after: IMMEDIATELY
Data type: DOUBLE
Significance:
9460
MD number
Standard value: HD
Change becomes effective after: IMMEDIATELY
Data type: LONG
Significance:
7-48
$MM_MA_SPIND_POWER_RANGE
Display area for spindle utilization
Min. input limit: 100
Protection level: 3/4
In this MD you stipulate the display range of the bar displaying spindle utilization. Depen-
ding upon the value entered, the displayed percentage values and the extension of the
color areas change.
Value entered = 100: Percentage values 0, 80, and 100% are displayed. The color display
changes from green to red starting at 80%.
Value entered = > 100, e.g. 200: Percentage values 0, 100, and 200% are displayed. The
colored display changes from green to red as of 100%.
$MM_WRITE_TOA_FINE_LIMIT
Limit value for wear fine
Min. input limit: –
Protection level: 3/4
With this MD you define the upper incremental limit (limit value for wear fine) for tool wear
(length, radius).
The incremental upper limit is only effective if the active protection level is greater than the
protection level set in MD 9203 USER_CLASS_WRITE_FINE.
The absolute upper limit is set in MD 9639 $MM_CTM_MAX_TOOL_WEAR.
$MM_WRITE_ZOA_FINE_LIMIT
Limit value for fine adjustment
Min. input limit: –
Protection level: 3/4
When entering the fine adjustment the difference between the previous value and the new
value must not exceed the value specified in this MD.
$MM_PROGRAM_SETTINGS
Settings in the Program area
Min. input limit: –
Protection level: 3/4
Bit 0 to 4: Reserved
Bit 5: Display hidden lines (;*HD*) in the G code editor
Bit 6: Reserved
Bit 7: Switch off G program checking during mold making
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
Max. input limit: ***
Units: %
Valid as of software version
ShopTurn 7.1
Max. input limit: –
Units: mm
Valid as of software version
ShopTurn 6.4
Max. input limit: –
Units: mm
Valid as of software version
ShopTurn 6.4
Max. input limit: –
Units: Hex
Valid as of software version
ShopTurn 6.4
© Siemens AG 2006 All Rights Reserved
11/2006