Siemens SINUMERIK 840D sl Commissioning Manual page 39

11/2006
Table 6-2 Signals from ShopTurn (output signals)
Address
DB82
DBX
37.0 CMM_OUT.program_selection_done
Acknowledgment from HMI that a program
has been selected
37.1 CMM_OUT.program_test_activ
Function for program test is active
37.2 CMM_OUT.dry_run_activ
Function for DryRun is active
37.3 CMM_OUT.m01_activ
Function M01 is active
37.4 CMM_OUT.skip_block_activ
Function for skipping record is active
37.7 CMM_OUT.start_up_activ
ShopTurn boot active
38.1 CMM_OUT.tool_un_load_internal
Load/unload tool without moving magazine
38.2 CMM_OUT.drf_activ
Function DRF is active
38.3 CMM_OUT.nc_start_ineffective
NC start has no effect
44 CMM_OUT.mask_number
Current screen number in ShopTurn
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
Name
Comments
6.3 Overview of earlier ShopTurn interface
Spares
Omitted because of the new start lock logic of the
NCK. The program can be selected and started
directly.
Standard interface signal
DB21.DBX33.7
Standard interface signal
DB21.DBX318.6
Standard interface signal
DB21. DBX32.5
Standard interface signal
DB21. DBX26.0ff
n.a.
Standard interface signal
DB71.DBX32.0 for the1st loading point
Standard interface signal
DB21.DBX24.3
Global start lock can be deactivated. Standard
interface signal DB21.DBX7.5
Standard interface signal
DB19.DBW24
6 Signal Description
J
6-39