Measuring Cycle Support In The G Code Editor - Siemens SINUMERIK 840D sl Commissioning Manual

11/2006
9.5

Measuring cycle support in the G code editor

ShopTurn on NCU
(HMI embedded)
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
9.5
In ShopTurn you can integrate screen forms which provide support for program-
ming measuring cycles into the G code editor. These cycles can then be recom-
piled automatically.
The "measuring cycles" function is a software option with Order No. 6FC5
800–0AP28–0YB0.
For more information on measuring cycle support please refer to:
References: /BNM/, Measuring Cycles User Manual
For startup proceed as follows:
S
Remove the semicolon ";" preceding the following lines in file STAN-
DARD_CYCLES\COMMON.COM:
;sc8406=aeditor.com
;sc8407=aeditor.com
By doing this, you create the connection between the softkeys used to call the mea-
suring cycles support and the configuration file of the support screens.
S
Remove the semicolon ";" preceding the following line in file STAN-
DARD_CYCLES\COMMON.COM:
;sc617=startup.com
You can modify the characteristics of the measuring cycle support in the
startup operating area.
S
Restart the machine.
S
If required, modify the characteristics for the measuring cycle support in the
"Startup" → ">" → "Measuring cycles" menu.
Measuring cycle support in the G code editor
;Measuring cycles for turning (horizontal softkey 6 on
;the expanded softkey menu in the
;G code editor)
;Measuring cycles for milling (horizontal softkey 7
;on the expanded softkey menu in the
;G code editor)
;Startup operating area (horizontal
;softkey 7 on the expanded softkey bar)
9 Additional Functions
9-143