Siemens SINUMERIK 840D sl Commissioning Manual page 126

8 Tool Management
8.9 Importing tool data
Example
8-126
If you do not define parameters, tool management will subsequently set them to
zero.
You must program the command "M30" at the end of the file.
For information about importing tool data into tool management, please refer to:
References: /BAT/, ShopTurn Operating/Programming Guide
;TOOL MAGAZINE ZEROPOINT,TOOL=2,MAGAZINE=0,NPV=0,BNPV=0
$TC_TP1[1]=1
$TC_TP2[1]=ROUGHING TOOL
$TC_TP3[1]=1
$TC_TP4[1]=1
$TC_TP5[1]=1
$TC_TP6[1]=1
$TC_TP7[1]=1
$TC_TP8[1]=2
$TC_TP9[1]=1
$TC_DP1[1,1]=500
$TC_DP2[1,1]=3
$TC_DP3[1,1]=35.92
$TC_DP4[1,1]=67.89
$TC_DP6[1,1]=0.6
$TC_DP8[1,1]=14
$TC_DP10[1,1]=93
$TC_DP11[1,1]=3.0
$TC_DP24[1,1]=2
...
M30
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
;Duplo number
;Tool "ROUGHING TOOL"
;Adjacent location on left unoccupied
;Adjacent location on right unoccupied
;Adjacent location above unoccupied
;Adjacent location below unoccupied
;Magazine location type
;Tool enabled
;Tool life monitoring
;Tool type, roughing tool
;Cutting edge position (left bottom)
;Length X
;Length Z
;Radius
;Tip length
;Holder angle
;Reference direction for holder angle
;–Z direction
;Tool clearance angle
;End of program
© Siemens AG 2006 All Rights Reserved
11/2006
J