Oki ES9466 Manual page 35

1.LOADING PAPER
When the paper is being fed into the equipment from the MPT
Be careful not to cut your fingers on the edge of paper when you hold it.
This could injure you.
 Do not mix different sizes of paper.
 Feed paper sheet by sheet from the MPT if you have set more than one copy in the number of copies setting.
 Slightly curl the paper. Hold it gently as it is being fed into the equipment.
 Make sure that the trailing edge of the paper will not be fed into the equipment while you are holding it.
 Printing is done at 300 dpi if the custom paper size is longer than the maximum standard paper size: for example,
the maximum custom size is 12.01 x 47.24 inches (305 x 1200 mm). Even if 300 dpi or more is selected, it is changed
to 300 dpi.
When the paper is coming out of the equipment
Be careful not to cut your fingers on the edge of paper when you hold it.
This could injure you.
 Support the paper gently as it is coming out of the equipment.
 Do not pull out the paper forcibly as it is exiting from the equipment.
Loading Paper on the MPT 35