Oki ES9466 Manual page 28

1.LOADING PAPER
3 When placing or removing copy paper, move the paper holding lever toward the outside. After
loading paper, move the paper holding lever back toward the equipment.
If paper cannot be fed, printing takes a long time after feeding or the quality is poor, turn over the paper and
place it again as shown in the figure or place fewer sheets.
The operating procedure for using the MPT differs depending on the paper size to be used. See the table below for the
operating procedure of each size.
Paper size
Other than North
America: A3, A4, B4, B5
North America: LD, LT,
LG, ST-R
Standard size Other than the above
Envelope
Tab paper
Others (Non-standard sizes)
 Copying from MPT stops when the paper placed on the MPT runs out during printing, even if the paper of the same
size is in any of the trays. Printing restarts when paper is supplied to the MPT.
 When you perform copying from MPT, the [RESET] button on the control panel blinks to indicate that copying has
completed. Press this button to switch copying from MPT to normal copying using the trays.
(Even if you do not press the [RESET] button, the copying from MPT mode will be cleared when the automatic
function clear mode kicks in after a specified period of time.)
28 Loading Paper on the MPT
 P.29 "Standard size paper on the MPT"
 P.30 "Envelopes on the MPT"
 P.32 "Tab paper on the MPT"
 P.33 "Non-standard paper on the MPT"
 P.34 "Long custom size paper on the MPT"
Procedure