Oki ES9466 Manual page 17

1.LOADING PAPER
6 Check that there is no gap between the paper and the side guides, as well as the paper and the
end guide.
If the gap is too wide, it could cause paper jamming, or the paper size could not be correctly detected.
Between the paper and side guides ("A" in the figure):
Make sure there is no gap. (0.5 mm (0.02") or less on one side, 1.0 mm (0.04") or less in total) However, if paper
jamming occurs, make a gap.
Between the paper and end guide ("B" in the figure):
Make sure there is no gap. (0.5 mm (0.02") or less)
Change the paper size indicator if required.
7
Push the tray straight into this equipment carefully until it comes to a stop.
8
The paper size setting screen appears.
The size of paper loaded in the envelope drawer is not automatically detected. Follow the procedure below to
change the paper size and type.
9 Open [Setting -User-] on the Home screen > [Tray].
A
A
B
Loading Paper in Trays 17