Analogue Output Channel Numbers; Pulse Input Card; Analogue Output Connection Details - Honeywell X Series User Manual

Analogue Output Channel Numbers

The Analogue Output cards are either 2 or 4 channels using a connector that only takes up
half the length of the connector slot. Looking from the rear of the unit the Analogue Out con-
nector is on the left of the Analogue slot with a blanking plate on the right.

Analogue Output Connection Details

Pulse Input Card

The
into a PCB header on the rear of the unit.
The Pulse Input card position for the Minitrend QX is shown in
and
The Pulse Input card is not available on the eZtrend QXe
O option card has 4 channels that can be set as pulse inputs (channels 1 to 4). The operat-
ing frequency for pulse inputs on the Digital I/O card is 1kHz max.
Input: Low < 1V, High >4V to <50V DC (8V to 50V p-p AC) or Volt free input: Low = short
circuit, High = open circuit.
22
Card Position
Channel number
Output 1 Output 2
1 2 3 4
Loop - NC
Loop + Loop -
connections are made via 1 x 12-way screw terminal plugs that fits
Pulse Input card
Figure 2.4 on page 15
Table 2.4 :
Analogue Output card
Slot B
9 to 12 33 to 36
Output 3
5 6 7 8 9 10 11 12
Loop +
Loop - NC
NC Loop + Loop -
for the Multitrend SX.
Slot E Slot F
41 to 44
Output 4
Loop +
NC
Figure 2.3 on page 14,
the 8 Digital I/
recorder, however,
43-TV-25-30 Iss.6 GLO Aug 07 UK
NC = Not
connected