Auto Wah; Od/Ds 0 Twah; Lofi Compress; Distortion - Roland V-Drums TD-50 Data List

Drum sound module
Hide thumbs Also See for V-Drums TD-50:
Table of Contents

Advertisement

AUTO WAH

Cyclically controls a filter to create cyclic change in timbre.
Parameter
Value
Filter Type
LPF, BPF
Manual
0–127
Peak
0–127
Sens
0–127
Polarity
UP, DOWN
Tempo Sync
OFF, ON
Rate
0.05–10.00 Hz, note Frequency of modulation
Depth
0–127
Phase
0–180 deg
Low Gain
-15–+15 dB
High Gain
-15–+15 dB
Level
0–127

OD/DS 0 TWAH

Parameter
Value
Drive Switch
OFF, ON

OVERDRIVE,

Drive Type

DISTORTION

Drive
0–127
Tone
0–127
Amp Switch
OFF, ON
SMALL, BUILT-IN,
Amp Type
2-STACK, 3-STACK
Touch Wah Switch OFF, ON
Touch Wah Mode LPF, BPF
Touch Wah
DOWN, UP
Polarity
Touch Wah Sens
0–127
Touch Wah
0–127
Manual
Touch Wah Peak
0–127
Touch Wah
D100:0W–
Balance
D0:100W
Low Gain
-15–+15 dB
High Gain
-15–+15 dB
Level
0–127
Explanation
Type of filter
LPF: The wah effect will be applied
over a wide frequency range.
BPF: The wah effect will be applied
over a narrow frequency range.
Adjusts the center frequency at
which the effect is applied.
Width of the frequency region at
which the wah effect is applied
Increasing this value will make the
frequency region narrower.
Adjusts the sensitivity with which the
filter is controlled.
Direction in which the filter will move
UP: Move toward a higher frequency
DOWN: Move toward a lower
frequency
Specifies whether the modulation
rate is specified as a note value (ON)
or not (OFF).
Depth of modulation
Adjusts the degree of phase shift of
the left and right sounds when the
wah effect is applied.
Gain of the low range
Gain of the high range
Output Level
Explanation
Turns overdrive/distortion on/off
Type of distortion
Degree of distortion
Also changes the volume.
Sound quality of the Overdrive effect
Turns the Amp Simulator on/off.
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
Wah on/off
Type of filter
LPF: Produces a wah effect in a broad
frequency range.
BPF: Produces a wah effect in a
narrow frequency range.
Direction in which the filter will move
UP: Move toward a higher frequency
DOWN: Move toward a lower
frequency
Sensitivity with which the filter is
modified
Center frequency at which the wah
effect is applied
Width of the frequency region at
which the wah effect is applied
Increasing this value will make the
frequency region narrower.
Volume balance of the sound that
passes through the wah (W) and the
unprocessed sound (D)
Gain of the low range
Gain of the high range
Output Level

LOFI COMPRESS

This is an effect that intentionally degrades the tone character for
creative purposes.
Parameter
Value
Pre Filter Type
1–6
LoFi Type
1–9
Post Filter Type
OFF, LPF, HPF
Post Filter Cutoff 200–8000 Hz
Low Gain
-15–+15 dB
High Gain
-15–+15 dB
Level
0–127

DISTORTION

This is a distortion effect that provides heavy distortion.
Parameter
Value
Drive
0–127
Tone
0–127
Amp Sw
OFF, ON
SMALL, BUILT-IN,
Amp Type
2-STACK, 3-STACK
Low Gain
-15–+15 dB
High Gain
-15–+15 dB
Pan
L64–63R
Level
0–127

OVERDRIVE

This is an overdrive that provides heavy distortion. The parameters
are the same as for "DISTORTION. "

SATURATOR

A saturator which distorts the sound is connected in parallel with
a compressor, producing a rougher tonal character and boosting
the loudness. This also cuts the low-frequency region of the input
audio.
Parameter
Value
Saturator Gain
0–127
Saturator Drive
0–127
Saturator Level
0–127
Comp Depth
0–127
Comp Level
0–127
Hi Gain
-12–+6 dB
Level
0–127
Multi-Effect Parameters
Explanation
Selects the type of filter applied to
the sound before it passes through
the Lo-Fi effect.
1: Compressor off
2–6: Compressor on
Degrades the tone character. The
tone character grows poorer as this
value is increased.
Selects the type of filter applied to
the sound after it passes through the
Lo-Fi effect.
OFF: no filter is used
LPF: cuts the frequency range above
the Cutoff
HPF: cuts the frequency range below
the Cutoff
Basic frequency of the Post Filter
Gain of the low range
Gain of the high range
Output Level
Explanation
Degree of distortion
Also changes the volume.
Sound quality of the Overdrive effect
Turns the Amp Simulator on/off.
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
Gain of the low range
Gain of the high range
Stereo location of the output sound
Output Level
Explanation
Input volume to the saturator
Degree of distortion
Output volume of the saturator
Amount of compression
Output volume of the compressor
Gain of the high range
Output Level
39

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents