Auto Off; Info - Roland V-Drums TD-50 Data List

Using the Local Control setting
If you're using a DAW with the performance data from the pads and TD-50's sound generator section, you
should turn the Local Control "OFF. " Here's why.
We need to connect these sections in the following order: the performance data from the pads 0
a DAW 0 the TD-50's sound generator section.
Since the performance data from the pads and TD-50's sound generator section are connected internally,
such a connection order would normally be impossible. However, if the Local Control is "OFF, " the
performance data from the pads and TD-50's sound generator section will be independent, allowing you to
use a DAW as shown here in the illustration.
Specifying the HH Note# Border
The note number transmitted when you strike the hi-hat will change depending on the amount of pressure on the hi-hat pedal.
At the factory default value (127), the closed hi-hat note number will be transmitted only if the hi-hat pad is played with the pedal completely depressed. If you want this note
number to be transmitted when the pedal is slightly raised, set this to a value such as "90. "
* In some cases, changing the hi-hat note number border setting might cause a song to play back differently than when it was recorded.

AUTO OFF

Parameter
Auto Off

INFO

Parameter
PROGRAM tab
Program Version
SAMPLE tab
Imported Sample
Memory Remain
SD CARD tab
Backup All
1 Kit
Rec Data
DIGITAL tab
Pad
Program Version
Value
Specifies whether the unit will turn off automatically after a certain time has elapsed. If you don't want the unit to turn off automatically,
choose "OFF" setting
OFF
4 HOURS
Value
Program version
Number of imported user samples
Remaining amount for user samples in user memory
Backup data saved on the SD card (all settings)
Kit backup data saved on the SD card
Number of recorded data saved on the SD card
Indicates a pad that is digitally connected to the TD-50.
Indicates the program version of a pad that is digitally connected to the TD-50.
Pad
Explanation
The power does not turn off automatically.
When four hours have elapsed without any pad being struck or any operation being performed, the
unit will turn off automatically.
Explanation
DAW
TD-50
Sound generator
section
Local Control: OFF
SETUP
33