Output Routing (Page 3) - Roland V-Drums TD-50 Data List

OUTPUT ROUTING (page 3)

Parameter
ROUTING tab
Fader to Direct*1
PadEq/Comp to Direct*1
PadComp to Phones
Master Out*1
LO CUT tab
LoCut Frequency
DirectOut*2
MasterOut*2
PhonesOut
ATT tab
Direct Out Att*2
*1 This also applies to the TD-50's sound that is output via USB audio.
*2 Low cut and attenuator do not apply to the TD-50's sound that is output via USB audio.
MEMO
To return to the default values, press the [F4] (DEFAULT) button.
Value
OFF, ON
OFF, ON
OFF, ON
NORMAL, DIRECT
20–200 Hz
OFF, ON
OFF, ON
OFF, ON
-12, -6, 0db
Explanation
Specifies whether the fader values are applied to the output from the DIRECT OUT jacks (ON) or are
not applied (OFF).
If this is "OFF, " the output from the DIRECT OUT jacks is not affected by the panel faders.
If the OUTPUT ROUTING Master Out is "DIRECT, " and Fader to Direct is "OFF, " the output from the
MASTER OUT jacks is also unaffected by the panel faders.
Regardless of the Fader to Direct setting, the output from the PHONES jacks is always affected by
the panel faders.
This means that the faders at hand can be used to adjust the balance of the sound monitored by
the performer, independently of the balance adjusted by the PA.
Specifies whether the pad equalizer (p. 14) and pad compressor (p. 14) effects are applied (ON) or
are not applied (OFF) to the sound that is output from the DIRECT OUT jacks.
If this is "OFF, " the pad equalizer and pad compressor are bypassed for the output of the DIRECT
OUT jacks.
If the OUTPUT ROUTING Master Out is "DIRECT, " and PadEq/Comp to Direct is "OFF, " the output from
the MASTER OUT jacks also bypasses the pad equalizer and pad compressor.
Specifies whether the pad compressor (p. 14) is applied (ON) or is not applied (OFF) to the sound
that is output from the PHONES jacks.
If this is "OFF, " the pad compressor does not affect the output from the PHONES jacks.
For example, this lets you use the pad compressor to reduce the dynamic range for the drum
monitor or PA, but hear the full dynamics in the monitor headphones while you perform.
Selects whether the output of the MASTER OUT jacks is the same signal as the DIRECT OUT jacks
(DIRECT) or not (NORMAL).
If this is "DIRECT, " the output of the MASTER OUT jacks is not affected by the master compressor
and master EQ, allowing you to use the MASTER OUT jacks as DIRECT OUT jacks (the setting of the
[MASTER] knob does apply).
This setting also applies to the USB audio output to your computer.
Cuts the frequency region below the specified frequency (low cut).
This setting is common to all output jacks.
Specifies whether low cut is applied (ON) or is not applied (OFF) to the sound that is output from
the DIRECT OUT jacks.
Specifies whether low cut is applied (ON) or is not applied (OFF) to the sound that is output from
the MASTER OUT jacks.
Specifies whether low cut is applied (ON) or is not applied (OFF) to the sound that is output from
the PHONES jacks.
Lowers the volume of the DIRECT OUT jacks (attenuator).
This lets you decrease the volume if the output of the TD-50 is too high, causing distortion on the
device that receives these signals.
This applies to all DIRECT OUT jacks.
If Master Out is set to "DIRECT, " this also applies to the output from the MASTER OUT jacks.
SETUP
29