Specifying The Output Routing - Roland V-Drums TD-27 Reference Manual

Specifying the Output Routing

Here's how to make settings for output routing to the
MASTER OUT jacks, DIRECT OUT jacks, and PHONES jacks.
1
Press the [SYSTEM] button.
The SYSTEM screen appears.
2
Use the cursor buttons to select "OUTPUT" and
press [ENTER] button.
3
Press the [F5] (ROUTING) button.
4
Press the [F1] (ROUTING)–[F3] (GAIN) buttons
to select the item that you want to edit.
Button Explanation
Specifies how the fader, pad equalizer/
[F1] (ROUTING) compressor, and master out output are
applied or routed.
Specifies whether the low-frequency
region is cut from the output.
[F2] (LO CUT)
The frequency setting is the same for
each output.
Adjusts the volume (gain) of the MASTER
OUT jacks, PHONES jack, and DIRECT OUT
jacks. Here you can lower the volume
if excessively loud output from the TD-27
causes distortion at the receiving device,
[F3] (GAIN)
or adjust the output from the PHONES
jack to an appropriate volume.
* Note that if the volume is too high,
distortion may occur.
Reference
For details on the parameters that can be edited, refer to
"Data List" (PDF).
5
Press the [DRUM KIT] button to return to the
DRUM KIT screen.
Making Various Settings (SYSTEM)
Routing parameter setting examples
Parameter Explanation
When turned "OFF"
5 The output from the DIRECT OUT jacks bypasses
the pad equalizer and pad compressor.
The output from the MASTER OUT jacks bypasses
PadEq/
the pad equalizer and pad compressor if the
Comp to
OUTPUT ROUTING Master Out setting is "DIRECT. "
Direct
5 While the equalizer and compressor for each
pad are adjusted at the PA, the performer can
perform with the sound processed by the pad
equalizer and pad compressor of each drum kit.
When turned "OFF"
5 The pad compressor does not apply to the
output from the PHONES jacks.
5 With settings such as shown in output
PadComp
destination setting example 2 (p. 56), you can
to Phones
hear the sound with full dynamics in your
monitor headphones as you perform, yet use the
pad compressor to reduce the dynamics for the
drum monitor and the PA.
With the "DIRECT" setting
5 The master compressor and master EQ effects are
not applied to the output from the MASTER OUT
jacks, allowing you to use the MASTER OUT jacks
as DIRECT OUT jacks (the setting of the [MASTER]
knob is applied). This setting also applies to the
output via USB audio to your computer.
Master Out
5 The PHONES jacks output the sound processed
by the master compressor and master EQ.
5 If you want the output of the MASTER OUT jacks
to be output as direct output, assign the output
to MASTER DIRECT in the PAD OUTPUT screen
(DIRECT tab) and the OTHER OUTPUT screen
(DIRECT tab).
57