Figure 2-9: The Waterproof Seal - Alvarion BreezeNET B System Manual

Chapter 2 - Installation
2 Unscrew the top nut from the waterproof seal.
3 Route a straight Category 5E Ethernet cable (8-wire, 24 AWG) through both
the top nut and the waterproof seal
NOTE
Use only Category 5E 4x2x24# FTP outdoor cables from an approved manufacturer. See list of
approved cables and length limitations in
4 Insert and crimp the RJ-45 connector. Refer to
preparing the cable.
5 Connect the Ethernet cable to the outdoor unit RJ-45 connector.
Replace the waterproof seal and then the top nut. Make sure that the external
6
jack of the cable is well inside the waterproof seal to guarantee a good seal.
Route the cable to the location selected for the indoor equipment.
7
Assemble an RJ-45 connector with a protective cover on the indoor end of the
8
indoor-to-outdoor cable.
BreezeNET B

Figure 2-9: The Waterproof Seal

.
Section 2.1.2
29
Installing the Outdoor Unit
.
Appendix C for instructions on
System Manual