Alvarion BreezeNET B System Manual page 160

Chapter 4 - Operation
operating channel and/or noise floor. During the Interference Mitigation process,
the scan readings and calculation results are updated in real-time in the Event
Log. At the end of the process, following the second reset, all feedback from
Interference Mitigation can be displayed by reading the Event Log [see
Menu" on page
4.2.6.2.18.4 Delete Statistics File
Deletes the Interference Mitigation statistics file created during the previous scan.
A final validation is required prior to deletion:
0 - Cancel Operation

1 - Delete File

4.2.6.2.18.5 Show Interference Mitigation Parameters & Data
This feature displays a review of the Interference Mitigation settings and the
statistics generated during the latest scan (if the statistics file was not deleted in
the meanwhile). These statistics include for each defined channel the following
parameters:
Frequency

Noise Floor

Achievable Distance

Maximum Throughput

4.2.6.3 Network Management Parameters
The Network Management Parameters menu enables protecting the Unit from
unauthorized access by defining a set of discrete IP addresses as well as IP
address ranges from which the unit can be managed using protocols such as
Telnet, FTP, TFTP, SNMP, DHCP and ICMP. This excludes management messages
generated in the unit, such as Traps or Ping Test frames, which are not filtered.
The direction from which management access is permitted can also be configured,
which means that management access may be permitted from the wireless
medium only, from the wired Ethernet only, or from both.
The Network Management Menu also enables managing transmission of traps,
including definition of up to 10 traps destination IP addresses and the associated
community strings. In addition, the menu enables specifying in the RB the IP
BreezeNET B
67] or by downloading the log file [see
136
Menus and Parameters
"Event Log
Appendix B].
System Manual