Connecting The Indoor-To-Outdoor Cable; Figure 2-5. Routing The Indoor-To-Outdoor Cable Through The Waterproof Seal - Alvarion BreezeNET DS.11 User Manual

Installation

2.7.2 Connecting the Indoor-to-Outdoor Cable

1. Remove the two screws holding the waterproof seal assembly to the Outdoor
unit and remove the waterproof seal.
2. Unscrew the top nut from the waterproof seal.

Figure 2-5. Routing the Indoor-to-Outdoor Cable through the Waterproof Seal

3. Route an uncrimped straight Ethernet cable (8-wire, 24 AWG pin-to-pin)
through the top nut and the waterproof seal.
Note: The 8-wire cable should be shielded.
4. Insert and crimp the RJ45 connector. Refer to Appendix A for instructions on
preparing the RJ-45 cable connector.
5. Connect the Ethernet cable to the Outdoor unit RJ45 connector.
6. Replace the waterproof seal assembly to the Outdoor unit and then replace the
top nut. Make sure that the external jack of the cable is well inside the service
box to guarantee a good sealing.
7. Route the cable to the location selected for the Indoor unit.
8. Assemble an RJ-45 connector with a protective cover on the indoor side of the
Indoor-to-Outdoor cable and connect it to the Indoor unit's Radio port.
User's Guide 2-16 BreezeNET BU-DS.11/RB-DS.11