Alvarion BreezeNET B System Manual page 89

Chapter 4 - Operation
Table 4-3: Parameters that are not changed after Set Partial Factory/Operator Defaults
Parameters Group
Service Parameters
Country Code Parameters
4.2.3.2.1.3 Set Complete Operators Defaults
Select this option to reset the unit to the Operator Defaults configuration,
excluding several parameters that are listed in
4.2.3.2.1.4 Set Partial Operator Defaults
Select this option to reset the unit to the Operator Defaults configuration,
excluding the parameters that are required to maintain connectivity and
management access. The parameters that do not change after Set Partial Operator
Defaults are listed in
4.2.3.2.1.5 Cancel Current Pending Request
After selecting one of the Set defaults options, it will be executed after the next
reset. This option enables to cancel the pending request before execution
(provided the unit has not been reset yet).
4.2.3.2.2 Save Current Configuration As Operator Defaults
The Save Current Configuration As Operator Defaults option is available only
under Administrator access rights. It enables defining the current configuration of
the unit as the Operator Defaults configuration.
4.2.3.3 Change Unit Name
The Change Unit Name option enables changing the name of the unit, which is
also the system's name in the MIB2. The name of the unit is also used as the
prompt at the bottom of each Monitor window.
Valid values: A string of up to 32 printable ASCII characters.
The default unit name is an empty string.
BreezeNET B
Parameter
Wireless Link Prioritization Option (BU-B14/28/100)
Low Priority AIFS (BU- B14/28/100)
Number of HW Retries for High Priority Traffic (BU- B14/28/100)
Number of HW Retries for Low Priority Traffic (BU- B14/28/100)
BU Burst Duration for High Priority Traffic (BU- B14/28/100)
BU Burst Duration for Low Priority Traffic (BU- B14/28/100)
RB Burst Duration for High Priority Traffic (BU- B14/28/100)
RB Burst Duration for Low Priority Traffic (BU- B14/28/100)
Low Priority Traffic Minimum Percent
Selected Country Code
Table 4-3.
65
Menus and Parameters
Table 4-2.
System Manual