Installation Requirements; Packing List (Bu, Rb) - Alvarion BreezeNET B System Manual

Chapter 2 - Installation
2.1

Installation Requirements

This section describes all the supplies required to install the BreezeNET B system
components and the items included in each installation package.
2.1.1

Packing List (BU, RB)

IDU indoor unit with a wall mounting kit

Mains power cord

ODU outdoor unit with an integrated antenna

Or
ODU outdoor unit with a connection to a detached antenna (not included)
Pole mounting kit for the ODU

An IDU to ODU cable kit, including 20m Category 5E Ethernet cable with a

shielded RJ-45 connector crimped on one end, a waterproof sealing assembly
and two shielded RJ-45 connectors (not applicable for BU/RB-B10).
2.1.1.1 Additional Installation Requirements
The following items are also required to install the BreezeNET B system:
Detached Antenna* (for D model units), including a pole mounting kit and an

RF cable
Ethernet cable (straight for connecting to a hub/switch etc., crossed for

connecting directly to a PC's NIC)
For BU/RB-B10 (or for other units if the Indoor-to-Outdoor cable supplied

with the equipment is not long enough) - Category 5 Ethernet cable with
shielded RJ-45 connectors * (available in different lengths. For more details
refer to
Crimping tool for RJ-45 connectors

Ground cables with an appropriate termination

BreezeNET B
Section 2.1.2)
16
Installation Requirements
System Manual