Reset Button Functionality - Alvarion BreezeNET B System Manual

Chapter 2 - Installation
5 Connect the 10/100 BaseT ETHERNET connector (located on the side panel of
the PS1073 IDU) to the network. The cable connection should be a straight
Ethernet if connecting the indoor unit to a hub/switch and a crossed cable if
connecting it directly to a PC Network Interface Card (NIC).
NOTE
The length of the Ethernet cable connecting the indoor unit to the user's equipment, together with
the length of the Indoor-to-Outdoor cable, should not exceed 100 meters.
2.4.1

RESET Button Functionality

Using a sharp object, press the recessed RESET push button for a short time to
reset the unit and reboot from the Main version.
In units with ODU HW revision C or higher, the RESET button can be used for
setting the unit to its factory defaults. Press the button for at least 5 seconds
(until the ETH LED of the IDU stops blinking): the unit will reboot with the factory
default configuration.
BreezeNET B
Installing the Universal IDU Indoor Unit
33 System Manual