Siemens SINUMERIK 802S Technical Manual page 88

Start-Up
Spindle setpoint adaptation
Reciprocation mode for gear change
4-48
Gear stage 2
Internal resolution = ------------------------- x -------------------------- x ------------------- x 1000incr/deg
Internal resolution = ----------------- x ------------- x ------------ x 1000pulses/deg = 43.945
4 x 2048
One encoder increment corresponds to 43.945 internal increments. One
encoder increment corresponds to 0.043945 degrees (minimum positioning
step).
To adapt the spindle setpoint and its gear stage, the following axis MD and
interface signals are relevant:
Number
32010 Rapid traverse in jog mode
32020 Jog axis velocity
35110 Maximum speed for gear change (gear stage no.): 0..5
35120 Minimum speed for gear change (gear stage no.): 0..5
35130 Maximum speed of gear stage (gear stage no.): 0...5
35140 Minimum speed of gearstage (gear stage no.): 0...5
35200 Acceleration in speed control mode [gear stage no.]: 0...5
31060 Numerator load gearbox (control parameter set no.): 0...5
31050 Denominator load gearbox (control parameter no.): 0...5
Interface signals
"Switch gear" 39032000 bit 3
"Actual gearstage" 38032000 bits 0 through 2
"No speed monitoring when switching the gear"
38032000 bit 6
"Gear has been switched"
38032000 bit 3
"Setpoint gear stage" 39032000 bits 0 through 2
"Positioning mode" 39032002 bit 5
"Reciprocation by PLC"38032002 bit 4
"Reciprocation mode" 39032002 bit 6
"Control mode" 39032002 bit 7
"Traversing minus" 39030004 bit 6
"Traversing plus" 39030004 bit 7
The default settings of these MD has been selected such that spindle motion is
possible both in the simulation mode (MD 30130=0) and with drive (MD
30130=1).
The reciprocation mode of the spindle is intended to facilitate the gear change.
For reciprocation mode, the following axis MD and interface signals are
relevant:
360 degrees MD 31080
MD 31020 x 4 MD 31070
360 1
1
Description
MD 31050
MD 31060
1
1
SINUMERIK 802S base line
Start-Up