Siemens SINUMERIK 802S Technical Manual page 105

34100 REFP_SET_POS
mm, Reference point value/irrelevant for distance–coded
deg. system: 0 ... 3
_always 0., 0., 0., 0.
34110 REFP_CYCLE_NR
– Sequence of axes in channel–specific referencing
–1: No obligatory reference point for NC Start
0: No channel–specific reference–point approach
1–15:
_always 1
34200 ENC_REFP_MODE
– Type of position measuring system
0: No ref. point appr.; if an absolute encoder exists:
REFP_SET_POS accepted
1: Zero pulse (on encoder track)
_always 1
35010 GEAR_STEP_CHANGE_ENABLE
– Gear change possible. Spindle has several gear steps
_always 0
35040 SPIND_ACTIVE_AFTER_RESET
– Own spindle reset
_always 0
35100 SPIND_VELO_LIMIT
rev/min Maximum spindle speed
_always 10000
35110 GEAR_STEP_MAX_VELO
rev/min Maximum speed for gear change (gear stage no.): 0..5
_always 500,
2000, 4000, 8000
35120 GEAR_STEP_MIN_VELO
rev/min Minimum speed for gear change (gear stage no.): 0..5
_always 50, 50, 400, 800,
1500, 3000
35130 GEAR_STEP_MAX_VELO_LIMIT
rev/min Maximum speed of gear stage (gear stage no.): 0...5
_always 500, 500, 1000, 2000,
4000, 8000
35140 GEAR_STEP_MIN_VELO_LIMIT
rev/min Minimum speed of gearsetp (gear stage no.): 0...5
_always 5, 5,10, 20, 40, 80
SINUMERIK 802S base line
Start-Up
–
Sequence in channel–specific reference point
approach
–1
0
***
***
0.0
500, 1000, 0.0
0.0
0.0
0.0
Technical Appendix
RESET
– DOUBLE
RESET
31 DWORD
POWER ON
6 BYTE
POWER ON
*** B O O LE A N 2/7
POWER ON
*** B O O LE A N 2/7
POWER ON
plus DOUBLE
NEW CONF
plus DOUBLE
NEW CONF
plus DOUBLE
NEW CONF
plus DOUBLE
NEW CONF
plus DOUBLE
2/7
2/7
2/7
2/7
2/7
2/7
2/7
2/7
6-11