Siemens SINUMERIK 802S Technical Manual page 101

31010 ENC_GRID_POINT_DIST
mm Division period for linear scales (encoder no.)
_always 0.01
31020 ENC_RESOL
– Encoder markings per revolution (encoder no.)
_always 2048
31030 LEADSCREW_PITCH
mm Pitch of leadscrew
_always 10.0
31040 ENC_IS_DIRECT
– Encoder mounted directly to the machine (encoder no:)
_always 0
31050 DRIVE_AX_RATIO_DENOM
– Denominator load gearbox (control parameter no.): 0...5
_always 1, 1, 1, 1, 1, 1
31060 DRIVE_AX_RATIO_NUMERA
– Numerator load gearbox (control parameter set no.): 0...5 POWER ON
_always 1, 1, 1, 1, 1, 1
31070 DRIVE_ENC_RATIO_DENOM
– Denominator resolver gearbox (encoder no.)
_always 1
31080 DRIVE_ENC_RATIO_NUMERA
– Numerator resolver gearbox (encoder no.)
_always 1
31090 JOG_INCR_WEIGHT
mm, Evaluation of an increment with INC/handwheel
degrees
31100 BERO_CYCLE
– Steps for monitoring rotation
2000
31110 BERO_EDGE_TOL
– Step tolerance for monitoring rotation
50
31350 FREQ_STEP_LIMIT
– Stepping rate at maximum velocity
Hz 250000
SINUMERIK 802S base line
Start-Up
0.0
0.0
0.0
***
1
1
1
1
10
10
0.1
Technical Appendix
POWER ON
plus DOUBLE
POWER ON
plus DWORD
POWER ON
plus DOUBLE
POWER ON
*** B O O LE A N 2/7
POWER ON
2147000000 DWORD
2147000000 DWORD
POWER ON
2147000000 DWORD
POWER ON
2147000000 DWORD
RESET
POWER ON
10000000 DWORD
POWER ON
10000000 DWORD
NEW CONF
4000000 DOUBLE
2/7
2/7
2/7
2/7
2/7
2/7
2/7
2/7
2/7
2/7
6-7