User Alarm - Siemens SINUMERIK 802S Technical Manual

Technical Appendix
6.3.6

User alarm

User alarm defined In SAMPLE
Interface
Alarm#
Address
700000 V16000000.0
700001 V16000000.1
700002 V16000000.2
700003 V16000000.3
700004 V16000000.4
700005 V16000000.5
700006 V16000000.6
700007 V16000000.7
700008 V16000001.0
700009 V16000001.1
700010 V16000001.2
700011 V16000001.3
700012 V16000001.4
700013 V16000001.5
700014 V16000001.6
700015 V16000001.7
Standard alarm defined In SAMPLE
Interface
Alarm #
Address
700016 V16000002.0
700017 V16000002.1
700018 V16000002.2
700019 V16000002.3
700020 V16000002.4
700021 V16000002.5
700022 V16000002.6
700023 V16000002.7
700024 V16000003.0
700025 V16000003.1
700026 V16000003.2
700027 V16000003.3
700028 V16000003.4
700029 V16000003.5
700030 V16000003.6
700031 V16000003.7
6-52
Alarm Description
Startup! PLC MD needed, see description of PLC Lib
X+ traverse keys not defined, check MD14510[26]
X - traverse keys not defined, check MD14510[27]
Y+ traverse keys not defined, check MD14510[28]
Y - traverse keys not defined, check MD14510[29]
Z+ traverse keys not defined, check MD14510[30]
Z - traverse keys not defined, check MD14510[31]
Turret # wrongly defined, MD14510[20] = 4/ 6
Turret clamping time undefined, check MD14510[21]
Turret monitoring time undefined, check MD14510[22]
Spindle brake time out range, check MD14510[23]
Lubricating interval out range, check MD14510[24]
Lubricating duration out range, check MD14510[25]
Inputs undefined, check MD14512[0]&MD14512[1]
Outputs undefined, check MD14512[4]&MD14512[5]
Alarm Description
DRIVES NOT READY, TOUCH K1 ON MCP
2
I /T ALARM FOR INFEED MODULE
SPINDLE START IMPOSSIBLE WHILE UNCLAMPED
UNCLAMPING IMPOSSIBLE WHILE SPINDLE RUN
PROGRAMMED TOOL #. > MAX. TURRET ON
TURRET#
TOOL NOT FOUND, MONITORING TIME UP
NO POSITION SIGNALS FROM TURRET
MOTOR BRAKE RELEASED FOR DRIVE
OPTIMIZATION
APPROACH REF. POINT AGAIN AFTER ROT.
MONITORING
SBR #
31
SBR #
33
35
46
40
SINUMERIK 802S base line
Start-Up
49