Siemens SINUMERIK 802S Technical Manual page 108

Technical Appendix
36060 STANDSTILL_VELO_TOL
mm/min, Maximum velocity/speed "axis/spindle stopped"
rev/min
_always 5 (0.014)
36100 POS_LIMIT_MINUS
mm, 1st software limit switch minus
deg.
_always –100000000
36110 POS_LIMIT_PLUS
mm, 1st software limit switch plus
deg.
_always 100000000
36120 POS_LIMIT_MINUS2
mm, 2nd software limit switch minus
deg.
_always –100000000
36130 POS_LIMIT_PLUS2
mm, 2nd software limit switch plus
deg.
_always 100000000
36200 AX_VELO_LIMIT
mm/min, Threshold value for velocity monitoring
rev/min (control parameter set no.): 0...5
_always 11500.,
11500., 11500., ...
36300 ENC_FREQ_LIMIT
Hz Encoder limit frequency
_always 300000
36302 ENC_FREQ_LIMIT_LOW
% Encoder limit frequency at which encoder is switched on
again. (Hysteresis)
_always 99.9
36310 ENC_ZERO_MONITORING
– Zero mark monitoring (encoder no.): 0,1
0:
HW monitoring on
1–99, >100:
during monitoring
100:
monitoring off
_always 0, 0
6-14
0.0
–
–
–
–
11500., 0.0
0
0
Zero mark monitoring off, encoder
Number of recognized zero mark errors
Zero mark monitoring off, encoder HW
0.0
NEW CONF
plus DOUBLE
RESET
– DOUBLE
RESET
– DOUBLE
RESET
– DOUBLE
RESET
– DOUBLE
NEW CONF
plus DOUBLE
POWER ON
plus DOUBLE
NEW CONF
100 DOUBLE
NEW CONF
plus DWORD
SINUMERIK 802S base line
2/7
2/7
2/7
2/7
2/7
2/7
2/7
2/7
2/7
Start-Up