Storing Phrases Frequently Used In Labeling; On The Recorder - Sony Walkman MZ-R909 Operating Instructions Manual

3
To label a track, press
" : Name" is flashing.
To label a group, press the control
towards . or N> until "GP :
Name" flashes in the display, then
press x .
To label a disc, press the control
towards . or N> until
" : Name" flashes in the display,
then press x .
The track, group, or disc is ready to
be labeled.
4
Follow steps 5 to 7 of "Labeling a
disc during stop" (page 57).
To cancel labeling
Press DISPLAY for 2 seconds or more.
Notes
• When the recording is stopped while labeling
a track, a group, or a disc during recording, or
when the recording moves on to the next track
while labeling a track, the input at that point is
entered automatically.
• "LP:" is automatically added at the beginning
of the track name for tracks recorded in
MDLP mode (page 29).
z
You can store phrases that you often use in
tracks (page 59).
Relabeling recordings
Follow the steps corresponding to the
labeling method until the track, group, or
disc is ready to be labeled. Enter a new
character over the one you want to
change, then keep pressing the jog dial for
2 seconds or more on the recorder and
keep pressing for 2 seconds or more on
x
the remote control.
Notes
• You cannot relabel premastered MDs or label
MDs that have not been recorded.
• The recorder is able to display, but cannot
label using Japanese "Katakana" characters.
• The recorder cannot rewrite a disc or track
name of more than 200 letters that was created
by another device.
x while
Storing phrases
frequently used in
labeling
Phrases that you often use in track, group,
or disc labeling can be stored in the
recorder's memory. There are two ways to
store phrases: storing a phase using the
Name Bank function, or storing a phrase
into the letter palette while performing the
labeling procedure into the letter palette.
Approximately 40 phrases of about 10
characters each (with a total character
count of about 600) can be stored in the
recorder's memory. The actual number
will depend on the length of each phrases.

On the recorder

./>
END SEARCH
Jog dial
Storing phrases into the name
bank (Name Bank function)
1
Press the jog dial, turn the dial until
"EDIT" flashes in the display, and
then press the dial again.
2
Turn the jog dial until "Name Bank"
flashes in the display, and then press
the dial.
3
Enter the phrase you want to store,
and then press the jog dial for 2
seconds or more.
"Entry!" appears in the display and
the phrase is stored.
CANCEL
59