Sony Walkman MZ-R909 Operating Instructions Manual page 24

1) By setting "REC-Posi" to "From End", recording operations will always start from the end of the
previously recorded material (page 33).
2)
A track mark is added at the point where you press X again to resume recording while pausing; thus
the remainder of the track will be counted as a new track.
3)
If you open the lid while "REC-Posi" is set to "From Here", recording will begin with the first track
the next time you record. Check the point to start recording on the display.
If the recording does not start
• Make sure the recorder is not locked (pages
20, 74).
• Make sure the MD is not record-protected
(page 77).
• Premastered MDs cannot be recorded over.
For models supplied with the AC plug
adaptor
If the AC power adaptor does not fit the wall
outlet, use the AC plug adaptor.
Notes
• "Data Save" or "TOC Edit" flashes while data
of the recording (the track's start and end
points, etc.) is being recorded. Do not move or
jog the recorder or disconnect the power
source while the indication is flashing in the
display.
• The lid does not open until "TOC Edit"
disappears in the display.
• If the power supply is disrupted (i.e. the
battery is removed or becomes exhausted or
the AC power adaptor is disconnected) during
a recording or editing operation, or while
"TOC Edit" appears in the display, then it will
not be possible to open the lid until power is
restored.
• You can make digital recording only from an
optical type output.
• When recording from a portable CD player,
set the CD player to pause, and then do the
recording procedure on the recorder.
• Note the following when recording from a
portable CD player:
—Some portable CD players may not be
capable of digital out unless powered by the
AC power. If this is the case, connect the
AC power adaptor to the portable CD player
and use it on AC power as the power source.
—On some portable CD players, optical
output may not be possible when using an
anti-skip function (e.g., ESP*). If this is the
case, turn off the anti-skip function.
∗ Electronic Shock Protection
24
z
• LINE IN (OPT) jack is for both digital and
analog input. The recorder automatically
recognizes the type of line cable and switches
to digital or analog input.
• The recording level is adjusted automatically.
To adjust the level manually, see "Adjusting
the recording level manually (Manual
recording)" (page 36).
• You can monitor the sound during recording.
Connect the supplied headphones/earphones
with remote control to i/LINE OUT and
adjust the volume by pressing VOL +/–. This
does not affect the recording level.