Adjustment Of Open-Top Burners; Adjustment Of Oven Standing Pilot; Adjustment Of Oven Burner; Calibration Of Oven Thermostat - Southbend S Series Owner's Manual

A
DJUSTMENTS
A
DJUSTMENT OF
Over-rated burners cause poor burner and pilot performance, resulting in less heat, and wasted gas.
ADJUSTMENT OF GAS OVEN BURNER
C
ALIBRATION OF
The oven thermostat control is carefully calibrated at the factory so that its dial settings closely match actual oven tem-
When checking the oven temperature, use a test instrument or a reliable mercury thermometer positioned in the center of
Proceed as follows:
2. After burner has been on about 15 minutes, check the oven temperature. The oven door should be open for as short a
readings are within 5 degrees of each other. The oven temperature is the midpoint of the "swing" range.
quired, the additional steps to be taken are these:
decrease the oven temperature and counterclockwise to increase the oven temperature. Do not allow the stem to turn.
Turn the adjustment screw only 5 degrees of rotation in the appropriate direction, then repeat Steps 2 and 3 to check
should be replaced.
A
DJUSTMENT OF
required to keep the griddle at that temperature. Always, however, the control must bypass enough gas to keep the entire
page 27):
1. Light the burner, then turn dial FULL ON.
3. Remove dial and bezel.
5. Replace bezel and dial, turning the dial clockwise until it locks in the OFF position.
PAGE 20 OF 31
O T B
PEN- OP URNERS
G O T
AS VEN HERMOSTAT
T
HERMOSTATIC
G B
RIDDLE YPASS

OWNER'S MANUAL 1191904 REV 2 (5/14)

S S R
ERIES ESTAURANT
F L
LAME EVEL
R
ANGES
-
-