Owner's Manual 1191904 Rev 2 (5/14 - Southbend S Series Owner's Manual

S S R
ERIES ESTAURANT
1. Secure the restraining-device bracket (item "B" in the following illustration) to a wall stud located as close as possible
to the appliance connector inlet and outlet connections. Use four #12 screws (items "C") and plastic anchors (items
"A") if necessary.
2. Install eye-bolt (item "F") to a frame member on the rear of the equipment. After checking carefully behind the frame
(6 mm) drilled hole and secure with a washer (item "H") and nylon lock nut (item "I").
4. Using the spring-loaded snap hooks, attach the restraining device to the bracket and the eye-bolt.
the appliance connector.
Figure 5
Installation of Restraint
Be sure all controls are turned off prior to disconnecting. After reconnecting, be sure all controls are turned off and all
pilots are lit.
Adequate means must be provided to limit the movement of the appliance without depending on the connector and
the quick-disconnect device or its associated piping to limit the appliance movement.
The restraining means should be attached to a frame member on the back of the range.

OWNER'S MANUAL 1191904 REV 2 (5/14)

R
ANGES
H G
I
C
F
NOTICE
I
NSTALLATION
A
B
E
D
PAGE 11 OF 31