Error Messages - Brother MFC-J3520 Service Manual

3.2

Error Messages

Error Message
B&W 1-sided Print
Only
Replace Ink
BT Call Sign On
(UK only)
Cannot Detect
Cannot detect Ink
volume
Cannot Print
Replace Ink
Comm.Error
Connection Failed
Cover is Open.
Data Remaining in
Memory
Disconnected
Document Jam
DR Mode in Use
High Temperature
Hub is Unusable.
Image Too Long
Image Too Small
Ink Absorber Full
Ink Absorber Near
Full
Ink low
State
After judging getting close to ink replacing
timing by the ink remaining sensor, ink
discharged for specified times.
Monochrome print only is available.
Since the BT Call sign is ON, the receiving
mode cannot be changed.
Cannot identify a ink cartridge.
Ink remaining counter in the ink cartridge
IC chip becomes 0.
After judging getting close to ink replacing
timing by the ink remaining sensor, ink
discharged for specified times.
FAX communication error.
Destination fax machine cannot make the
polling setting.
scanner sensor detects that
Document
scanner is open.
document
ADF cover sensor detects opened cover
state.
Ink cartridge cover sensor detects opened
cover state.
Data cannot be processed due to memory
full.
Destination fax machine stops.
Document scanning position sensor
detects paper jam inside ADF.
Since the Distinctive Ring mode is set, the
receiving mode cannot be changed from
Manual to other mode.
Casing internal thermistor detects that
room temperature is too high.
USB hub or USB device with a built-in hub
is set.
Image is too long to correct.
Image is too small to trim.
Purge count or flushing count reach upper
threshold.
Purge counter is near upper threshold.
Ink remaining sensor detects near ink
replacing timing.
2-15
Error Refer to
Code page:
27, 28, 29 2-26
20, 21, 22, 2-24, 2-25
23, 24, 25
2-86
(4.10.6)
26, 27, 28, 2-26
29
2-83 (4.9)
A1 2-45
A4 2-46
2F 2-28
A2, A3 2-45, 2-46
40 2-33
46 2-34
Confidential