Mitsubishi MELSEC-A Series Reference Manual page 143

7. DATA LINK SETTINGS
(1) Default values
The default values of the network refresh parameters are assigned according to the
setting of the number of modules.
No settings are required unless specific changes must be made to the default values.
Table 7.1 shows the default values. The module Nos. correspond to the numbers in
the setting of the number of modules.
When a MELSECNET
area of module No. 1. If two MELSECNET
assigned to the area for one module.
Table 7.1 Default values of network refresh parameters
Number of mounted modules
1
2
data link module is mounted, it is always assigned to the
data link modules are mounted, they are
Module No. 1
LB/LW0 to FFF B/W0 to FFF
LX/LY0 to 7FF X/Y0 to 7FF
-
7 - 5
Module
Module No. 2
-
-