Suzuki Wagon R Manual page 1756

Rear Axle Shaft Oil Seal
REMOVAL
1) Remove rear axle shaft. For details, refer to steps 1) to 8) of
"REAR AXLE SHAFT AND WHEEL BEARING" in this sec-
tion.
2) Remove rear axle shaft oil seal (1) by using special tool.
Special tool
(A) : 09913-50121
2. Axle housing
INSTALLATION
1) Using special tool, drive in new oil seal (1) until it contacts oil
seal protector (2) in axle housing.
NOTE:
• Make sure that oil seal is free from inclination as it is
installed.
• Refer to figure so that oil seal is installed in proper
direction.
Special tool
(A) : 09944-67010
(B) : 09924-74510
"A" : Grease 99000-25010
A : Differential side
2) For procedure hereafter, refer to steps 4) to 16) of "REAR
AXLE SHAFT AND WHEEL BEARING" in this section.
REAR SUSPENSION 3E-3