Suzuki Wagon R Manual page 1391

CAUTION:
• Do not use lubricated shop air on brake parts as damage to rubber components may result.
• If any hydraulic component is removed or brake line disconnected, bleed the brake system.
• The torque values specified are for dry, unlubricated fasteners.
• Do not allow brake fluid to get on painted surfaces. Painted surfaces will be damaged by brake fluid.
Rear Brake Hose/Pipe (For Vehicle with LSPV)
REMOVAL
1) Raise and suitably support vehicle. Remove tire and wheel.
2) Clean dirt and foreign material from both hose end or pipe end fittings. Remove brake hose or pipe.
INSTALLATION
Reverse removal procedure for brake hose or pipe installation procedure.
• Install clamps properly referring to figure below.
• When installing hose, make sure that it has no twist or kink.
• Fill and maintain brake fluid level in reservoir. Bleed brake system.
• Perform brake test and check each installed part for fluid leakage.
1. 4 way joint
2. LSPV assembly
3. Rear brake hose
4. To left rear wheel cylinder
5. To right rear wheel cylinder
6. From master cylinder (Primary)
7. From master cylinder (Secondary)
On-Vehicle Service
A : Viewed from A
F : Front side
L : Left side
R : Right side
T : Top side
a – f : Clamp
Tightening Torque
BRAKES PIPE/HOSE/MASTER CYLINDER 5A-3