Suzuki Wagon R Manual page 1488

7F-18 REAR DIFFERENTIAL
4) Check gear tooth contact as follows.
a) After cleaning tooth surface of drive bevel gears, paint them
with gear marking compound evenly by using brush or
sponge etc.
CAUTION:
When applying red lead paste to teeth, be sure to paint
tooth surfaces uniformly. The paste must not be too dry
or too fluid.
b) Turn gear to bring its painted part in mesh with bevel pinion
and turn it back and forth by hand to repeat their contact.
c) Bring painted part up and check contact pattern, referring
to the following chart. If contact pattern is not normal, read-
just or replace as necessary according to instruction in
chart.
NOTE:
Be careful not to turn bevel gear more than one full revo-
lution, or it will hinder accurate check.
5) After completing of gear tooth contact check caulk compan-
ion flange nut (2) with caulking tool (1) and hammer.
6) Install dynamic damper (1).
Tighten bolts to specified torque.
Dynamic damper bolt
(a) : 23 N·m (2.3 kg-m, 17.0 lb-ft)