Ip Arp Inspection Entry Interface - Planet Networking & Communication MGSW-28240F Command Manual

arp Address Resolution Protocol
inspection ARP inspection
Default:
N/A
Usage Guide:
To enable ARP inspection
Example:
To enable ARP inspection
Switch# configure terminal
Switch (config)# ip arp inspection

4.2.59 ip arp inspection entry interface

Command:
ip arp inspection entry interface [10GigabitEthernet | GigabitEthernet] <vlan_id>
<mac_ucast> <ipv4_ucast>
ip Internet Protocol
arp Address Resolution Protocol
inspection ARP inspection
entry arp inspection entry
interface arp inspection entry interface config
GigabitEthernet
10GigabitEthernet
<vlan_id> Select a VLAN id to configure
<mac_ucast> Select a MAC address to configure
<ipv4_ucast> Select an IP Address to configure
Default:
N/A
Usage Guide:
To configure Static ARP Inspection Table.
Example:
To configure Static ARP Inspection Table as below table.
1 Gigabit Ethernet Port
10 Gigabit Ethernet Port
Command Guide of MGSW-28240F
-172-