4.2.56.13 dot1x port-control
Command:
dot1x port-control auto | force-authorized | force-unauthorized | mac-based | multi |
single
dot1x
port-control
Sets the port security state.
auto
force-authorized
force-unauthorized
mac-based
multi
single
Default:
Force-authorized
Usage Guide:
To configure Port-control mode for 802.1X
Example:
To configure Port-Based 802.1X(Auto) mode for GigabitEthernet X/X.
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # dot1x port-control auto
4.2.56.14 dot1x radius-qos
Command:
dot1x radius-qos
dot1x
radius-qos
Default:
Disable
Usage Guide:
To enable RADIUS-assigned QoS for 802.1X
Example:
To enable RADIUS-assigned QoS for GigabitEthernet X/X.
IEEE Standard for port-based Network Access Control
Port-based 802.1X Authentication
Port access is allowed
Port access is not allowed
Switch authenticates on behalf of the client
Multiple Host 802.1X Authentication
Single Host 802.1X Authentication
IEEE Standard for port-based Network Access Control
Enables/disables per-port state of RADIUS-assigned QoS.
Command Guide of MGSW-28240F
-87-