Spanning-Tree Edge; Spanning-Tree Link-Type - Planet Networking & Communication MGSW-28240F Command Manual

4.2.56.110 spanning-tree edge

Command:
spanning-tree edge
spanning-tree
edge
Default:
Non-Edge
Usage Guide:
To enable edge port of CIST Normal Port Configuration for specific interface
Example:
To enable edge port of CIST Normal Port Configuration for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # spanning-tree edge

4.2.56.111 spanning-tree link-type

Command:
spanning-tree link-type auto | point-to-point | shared
spanning-tree Spanning Tree protocol
link-type Port link-type
auto Auto detect
point-to-point Forced to point-to-point
shared Forced to Shared
Default:
Auto
Usage Guide:
To configure point to point mode of CIST Normal Port Configuration for specific interface
Example:
To enable point to point mode (shared) of CIST Normal Port Configuration for GigabitEthernet X/X
Switch# configure terminal
Spanning Tree protocol
Edge port
Command Guide of MGSW-28240F
-139-