Status And Error Messages On The V810 And V820 Operating Panels - DURKOPP ADLER 367 Operating Instructions Manual

7.5

Status and error messages on the V810 and V820 operating panels

30
General information
V810 V820
InF A1 InFo A1
StoP symbol "G"
flashes "cut-out"
flashes
InF A3 InFo A3
InF A5 InFo A5
Programming error message
V810 V820
If InFo F1
jumps back
to 1st digit
Hardware and software error messages
V810 V820
InF E1 InFo E1
InF E2 InFo E2
InF E3 InFo E3
InF E4 InFo E4
InF H1 InFo H1
InF H2 InFo H2
Meaning
The pedal is not in its zero position when the
sewing drive is switched on
The cut-out is active
Reference position not stored.
For programming see set-up instructions.
No valid Autoselect resistance
detected. For information see set-up
instructions
meaning
Incorrect code or parameter number
entered
meaning
After main switch on:
proximity or commutation switch
defective or connection lead wrongly connected.
During or after a sewing run:
proximity switch defective.
Mains voltage too low or the time between
main switch OFF and main switch ON was
too short.
Machine is blocked or not reaching the
required rotation speed
Control disrupted by defective earthing
or defective plug connections
(contact error).
Commutation-switch lead is defective or
the power electronics for the generation of the
rotating field is faulty.
Processor faulty.