Creating a MIP Image Rendering
LOGIQ
500 Advanced Reference Manual
2276614–100 Rev. 0
1. Perform a standard 2D scan in B- or CFM-Mode. The
images to be used for 3D construction will be stored in
Cine memory during scanning.
2. Press Freeze directly after the desired anatomy is
scanned. Remember that Cine memory is limited.
Activate Cine Gauge by rotating the Cine Scroll knob.
3. Display the Cine Sub-Menu page 3 by pressing the
Sub-Menu Select rocker switch. Rotate the Cine
Scroll knob to the position of the desired Start Frame,
as shown in Figure 3–3. Select Start Frame on the
Cine Sub-Menu page 3.
Figure 3–3. Start Frame
4. Rotate the Cine Scroll knob to the position of the
desired End Frame as shown in Figure 3–4. Select
End Frame on the Cine Sub-Menu page 3.
Figure 3–4. End Frame
3DvieW Mode
3–7