Coolant - Yamaha Grizzly 300 Owner's Manual

4. Install the drain bolt, and then tighten it to the
specified torque.
Tightening torque:
Final gear oil drain bolt:
30 Nm (3.0 m·kgf, 21.7 ft·lbf)
5. Add the specified amount of the recommended
final gear oil, and then check the oil level.
Recommended final gear oil:
See page 10-1.
Oil quantity:
0.15 L (0.16 US qt, 0.13 Imp.qt)
NOTICE
8
Be sure no foreign material enters the final
gear case.
6. Install and tighten the final
Tightening torque:
Final gear filling bolt:
15 Nm (1.5 m·kgf, 10.8 ft ·lbf)
7. Check the final
is leaking, check for the cause.
gear oil filler bolt.
gear case for oil leakage. If oil

Coolant

The coolant level should be checked before each
ride. In addition, the coolant must be changed at
the intervals specified in the periodic maintenance
and lubrication chart.
To check the coolant level
1. Place the ATV on a level surface.
TIP
The coolant level must be checked on a cold en-
gine since the level varies with engine tempera-
ture.
2. Check the coolant level in the coolant reser-
voir.
TIP
The coolant should be between the minimum and
maximum level marks.
8-18