Yamaha Grizzly 300 Owner's Manual page 118

4. Push the headlight bulb hold cables inward,
pull it outward as shown.
1. Headlight bulb holder
8 2. Headlight bulb hold cables
5. Remove the burnt-out bulb by pulling it out.
6. Place a new headlight bulb into position, and
then secure it with the bulb holder.
Do not touch the glass part of the headlight
bulb to keep it free from oil, otherwise the
transparency of the glass, the luminosity of
the bulb, and the bulb life will be adversely
affected. Thoroughly clean off any dirt and
1
2
2
NOTICE:
finger prints on the headlight bulb using
a cloth moistened with alcohol or thinner.
1
1. Do not touch the glass part of the bulb.
7. Install the bulb hold cables by pushing them
frontward and pulling them intward.
8. Install the bulb holder cover and the cover at
the rear of the headlight. NOTICE: Make sure
the headlight bulb holder cover is securely
fitted over the bulb holder and seated
properly.
9. Adjust the headlight beam if necessary.
8-46