Engine Oil - Yamaha Grizzly 300 Owner's Manual

Engine oil

The engine oil level should be checked before
each ride. In addition, the oil must be changed at
the intervals specified in the periodic maintenance
and lubrication chart.
To check the engine oil level
1. Place the ATV on a level surface.
2. Remove engine oil cap cover, push upward
on the areas shown, and then pull outward as
shown.
8
1. Engine oil cap cover
3. Check the engine oil level on a cold engine.
TIP
If the engine was started before checking the oil
level, be sure to warm up the engine sufficiently,
and then wait at least ten minutes until the oil set-
tles for an accurate reading.
4. Remove the engine oil filler cap, and then wipe
1
1. Engine oil filler cap
2. Engine oil dipstick
5. Insert the dipstick into the filler hole (without
8-12
the engine oil dipstick off with a clean rag.
screwing it in), and then remove it again to
check the oil level.
1
2