Rear Panel - Sony HKCU-FP2 Operation Manual

d MENU control block
DISP/MENU (display/menu) lever and indicator
CANCEL/ENTER lever
Control knob
• DISP/MENU (display/menu) lever and indicator
Selects the status display or setup menu display. In setup
menu mode, the indicator turns on.
• CANCEL/ENTER lever
In setup menu mode, used to cancel and enter settings.
• Control knob (rotary encoder)
In status screen mode, used to change the displayed page. In
setup menu mode, used to move the cursor on a page and to
change menu settings.
Pressing the control knob performs the same function as
setting the CANCEL/ENTER lever to the ENTER position.
e POWER switch
Switches the power for the entire system on and off, including
the CCU, camera, and the RCP-1000-series Remote Control
Panel connected to the REMOTE connector on the rear panel.
Pressing the "?" side turns the camera system on, and
pressing the "a" side turns it off.

Rear Panel

Memory stick slot (for use
by service personnel only)
a REFERENCE IN/OUT (reference input) connectors
(BNC type)
Inputs an HD tri-level reference sync signal or SD reference
sync signal (black burst signal) on either of the two connectors.
The input signal is output from the other connector as-is (loop-
through output). The signal is input on the upper connector.
The lower connector is terminated automatically if no
connector is connected.
8
Locations and Functions of Parts
f POWER indicator
CAM: Turns on when power is supplied to the camera.
MAIN: Turns on when the CCU power supply is turned on. It
flashes when there is a problem with the fan.
g NETWORK indicator
Displays the network system connection status.
On: Indicates that external control equipment
(MSU-1000/1500 Master Setup Unit, RCP-1000-series
Remote Control Panel, or other device) is connected.
Flashing: Indicates a connection problem with the external
control equipment (MSU-1000/1500 Master Setup Unit,
RCP-1000-series Remote Control Panel, or other device).
Off: Indicates that a LAN cable is not connected or that the
network system connection parameters have not been set.
See "Network diagnostics" on page 14 and "NETWORK
SETTINGS menu" on page 28.
h CABLE CONDITION indicators
Indicates the communication status of the camera (CAM) and
camera control unit (CCU).
When the two lamps on the right (green) are lighted:
Reception status is excellent.
When the second lamp from the right (green) is lighted:
Reception status is good.
When the second lamp from the left (yellow) is lighted:
Reception status is low.
When the lamp on the left (red) is lighted: Reception status
is at the lowest level.
• On the HSCU300RF, determined by the receive level of the
optical signal on the camera and CCU.
• On the HSCU300R, determined by the receive level of the
RF signal on the CCU.
a b c d e f g
l m n o p
b PROMPTER 1, 2 (teleprompter input 1, 2) connectors
(BNC type)
Inputs the VBS signals for the teleprompter.
Note
On the HSCU300RF, only one system from the two systems on the
PROMPTER1 and 2 connectors is enabled.
c VBS RETURN 1, 2 (VBS return video 1, 2 input)
connectors (BNC type)
Inputs the 2-system VBS return video signals.
h i j k
HSCU300RF diagram shown.