Sony HKCU-FP2 Operation Manual page 22

Page name
Page No.
<MONITOR 2>
C04
<MIC/AUDIO>
C05
<INTERCOM>
C06
22
Setup Menu
Item Settings
LEVEL GATE ---, 1&2, 1, 2, OFF
Y LEVEL1 0 to 108% 49 61
–99 to 99 –25
Y LEVEL2 0 to 108% 74 108
–99 to 99 –25
GATE MARKER ---, ON, OFF
–99 to 99 0
MODULATION ---, ON, OFF
–99 to 99 0
MARKER ON, OFF
4:3, 13:9, 14:9, EU VISTA, VISTA,
CINEMA, FOLLOW DC
CAM MIC GAIN (REMOTE), (LOCAL)
CH1 ---, 20, 30, 40, 50, 60 dB
CH2 ---, 20, 30, 40, 50, 60 dB
MIC REMOTE MIC 1&2, MIC 1.2
MIC OUT
DELAY 0, 256, 512, 768, 1024, 1280,
1536, 1792, 2048, 2304, 2560,
2816, 3072, 3328, 3584, 3840FS
MIC1 LEVEL –20, 0 +4 dBu
MIC2 LEVEL –20, 0 +4 dBu
CAMERA (ENG/MIC ON), (---/MIC OFF),
(PROD/MIC ON)
SYSTEM I/F CLEAR COM, 4 WIRE, RTS
TERMINATION (OFF), ON, OFF
PGM1 INPUT –20, 0, +4 dBu
PGM2 INPUT –20, 0, +4 dBu
Indication
---: Displayed when camera not connected, video
output not set to CAMERA, or video output is set to
CAMERA and GATE MARKER is ON (read only)
Level gate 1 minimum and maximum detection levels
and zebra range settings
Level gate 2 minimum and maximum detection levels
and zebra range settings
Gate signal display on/off and signal level setting
---: Displayed when camera not connected (read only)
4:3 aspect ratio mask function on/off when EDGE
CROP is ON, and mask video level setting
---: Displayed when camera not connected (read only)
Marker signal on/off and superimposed signal
selection
Camera microphone gain settings
(REMOTE): MIC REMOTE source
(LOCAL): Not MIC REMOTE source
Set to match the microphone used.
---: Displayed when camera not connected (read only)
MIC REMOTE gain control method
MIC 1&2: MIC 1, 2 common gain control
MIC 1.2: MIC 1, 2 independent gain control
MIC OUT 1, 2 delay setting
(3584, 3840FS: HSCU300RF only)
Camera settings
D-sub 25-pin intercom interface settings
200 Ω, termination when 2WIRE is set to ON.
(OFF): When SYSTEM I/F is 4WIRE (read only)
PGM1 input level setting
PGM2 input level setting