Sony HKCU-FP2 Operation Manual page 28

NETWORK SETTINGS menu
Page name
Page No.
<TCP/IP SETTING>
N01
<LAN SETTINGS>
N02
<CNS SETTINGS>
N03
<NETWORK RESET>
N04
28
Setup Menu
Item Settings
IP ADDRESS 0.0.0.0 to 255.255.255.255
SUBNET MASK 0.0.0.0 to 255.255.255.255
DEFAULT GATEWAY 0.0.0.0 to 255.255.255.255
SET ENTER to execute
AUTO NEGOTIATION ON, OFF
CONNECTION 10M, 100M
SPEED
DUPLEX MODE HALF, FULL
LINK CONDITION (DOWN), (UP)
SET ENTER to execute
CNS MODE LEGACY, BRIDGE, MCS
CCU NO Default: 0
MASTER IP 0.0.0.0 to 255.255.255.255
ADDRESS
ALL RESET ENTER to execute
Indication
IP address setting
Subnet mask display
Default gateway display
A "SET OK?" message is displayed. Press ENTER
again to confirm the change.
Auto negotiation on/off of connection speed and
communication mode with connected device
Connection speed selection
10M: 10BASE-TX
100M: 100BASE-TX
Configurable only when AUTO NEGOTIATION is off.
Communication method selection
HALF: Half-duplex communication
FULL: Full-duplex communication
Configurable only when AUTO NEGOTIATION is off.
Communication mode display (read only)
(DOWN): Not connected correctly
(UP): Connected successfully
A "SET OK?" message is displayed. Press ENTER
again to confirm the change.
Network connection mode selection
LEGACY: External controller connected using CCA-5
cable only
BRIDGE: External controller connected using
point-to-point LAN cable
MCS: (MCS mode operation available only when the
multi-camera control system support software is
installed.) Multi-camera system configuration of
multiple network-capable devices. Requires 1
MSU-1000/1500 Master Setup Unit in the system as
master device
When CNS MODE is LEGACY or BRIDGE:
1 to 96, A to Z
When CNS MODE is MCS: 1 to 24
Displayed only when the multi-camera control system
support software is installed.
A "NET SETTINGS RESET OK?" message is
displayed. Press ENTER again to reset NETWORK
SETTINGS menu items to factory default values.