Menu List - Sony HKCU-FP2 Operation Manual

Menu List

Note
The following conventions are used in the menu list table.
Settings column values (e.g. ON, OFF, 0): Default settings
ENTER to execute: Press the control knob or move the CANCEL/ENTER lever to the ENTER position to execute.
SYSTEM OPERATION menu
Page name Item
Page No.
<OUTPUT SELECT> OUTPUT
S01
PIX
WF
LASER DIODE
<GENLOCK PHASE> REFERENCE
S02
GENLOCK
SYNC OUT
<MULTI FORMAT> FREQUENCY
S03
Note
FREQUENCY or
CAMERA FORMAT
mode setting changes
take effect only after the
CCU power supply is
turned off and then on
again.
CAMERA FORMAT
Settings
CAMERA, BAR, TEST1, TEST2
ENC, R, G, B, R&G, G&B, R&B,
RGB
ENC, R, G, B, SEQ, R&G, G&B,
R&B, RGB
ON, OFF
(NONE), (EXT IN)
HD, SD
(OK), (NG)
External reference signal format
H STEP When GENLOCK is HD:
–3.01 to 3.45 µsec 0.00
When GENLOCK is SD:
–8.29 to 9.48 µs 0.00
COARSE –99 to 99 0
SC PHASE 0 to 359
V PHASE 0 to 7
HD SYNC, SD SYNC
1.001, 1.000
(525 NTSC), (625 PAL)
(Read only)
When FREQUENCY is 1.001:
(525 NTSC)
(625 PAL): When FREQUENCY
is 1.000
When FREQUENCY is 1.001:
1080/59.94i, 720/59.94P
When FREQUENCY is 1.000:
1080/50i, 720/50P
Indication
Output signal selection
TEST1 and TEST2 are not selectable if there is no
communication with the camera.
PIX connector output signal selection
WF connector output signal selection
Optical output ON/OFF from the CCU (HSCU300RF
only)
Reference signal input status (read only)
External reference signal lock mode selection, lock
status, and signal format
External reference signal lock status (read only)
(OK): Locked
(NG): Unlocked
Displayed only when a reference signal is present
(read only)
Reference signal lock phase adjustment (horizontal
phase, step)
Reference signal lock phase adjustment (horizontal
phase)
Subcarrier phase adjustment
Reference signal lock phase adjustment (vertical
phase)
SYNC connector output signal selection
Operating frequency selection
Note
The default setting is different among the sales
areas.
United States and Canada: 1.001
Other areas: 1.000
Note
The default setting is different among the sales
areas.
United States and Canada: (525 NTSC)
Other areas: (625 PAL)
Transmission format selection
Note
The default setting is different among the sales
areas.
United States and Canada: 1080/59.94i
Other areas: 1080/50i
19
Setup Menu