Sony HKCU-FP2 Operation Manual page 23

Page name Item
Page No.
<FRONT INCOM>
C07
INCOM MIC
MIC TYPE
MIC GAIN
SIDE TONE
PGM MIX
PGM SEL
PGM1 LVL
PGM2 LVL
<PROMPTER> MODE
C08
TRANSFER
INPUT
<VIDEO SETUP> SETUP
C09
Q FILTER
SD G/Y SYNC
WF SYNC
Settings
(MIC ON), (OFF), (PGM ON)
(PRIVATE), (PROD), (ENG)
CARBON, ECM, DYNAMIC
BALANCE, UNBALANCE
–6dB, 0dB, +6dB
0 to 99 50
OFF, INCOM+PGM,
L-INCOM/R-PGM
PGM1, PGM2, PGM1+PGM2
0 to 99, 50
0 to 99, 50
NORMAL, LOW LATENCY
VBS, SD-SDI, HD-SDI,
(VBS Y Only)
PROMPTER1, PROMPTER2
RET-SDI1, RET-SDI2
ON, OFF, --
NARROW, WIDE, --
ON, OFF
ON, OFF
Indication
CCU front panel MIC/PGM switch position (read only)
CCU front panel INTERCOM switch position (read
only)
Headset microphone type connected to INTERCOM
on the front panel
CARBON: Carbon microphone (power supply, 20 dB
gain)
ECM: Electret condenser microphone (power supply,
40 dB gain)
DYNAMIC: Dynamic microphone (no power supply,
60 dB gain)
Headset microphone type connected to INTERCOM
on the front panel
BALANCE: Balanced microphone
UNBALANCE: Unbalanced microphone
Input gain setting
Side tone level setting
OFF: PGM MIX disabled
INCOM+PGM: INCOM and PGM mixing
L-INCOM/R-PGM: INCOM output on left and PGM
output on right
PGM output settings
PGM1 level setting
PGM2 level setting
Video resolution mode switch (HSCU300R only)
NORMAL: Color picture transmitted as-is in standard
resolution with delay of approximately 5 frames
LOW LATENCY: SD B&W picture transmitted as low
resolution simplified images on the VBS Y line only
with delay less than 1 frame
(HSCU300R only)
VBS: VBS signal from PROMPTER connector sent to
camera as teleprompter
SDI: Digital signal from RETURN INPUT connector
sent to camera as teleprompter (disabled when an
HSC100R or HXC-100 is connected)
(VBS Y Only): Displayed when MODE is LOW
LATENCY (read only)
Number of prompter circuits setting
HD SDI/SD SDI switch (HSCU300R only)
Displayed when TRANSFER is set to SDI
Disabled when an HSC100R or HXC-100 is
connected
RET-SDI1: Uses the SDI RETURN 1 connector input
signal
RET SDI2: Uses the SDI RETURN 2 connector input
signal
ON: Setup on VBS and SD YCD component signal
Ych-SYNC
OFF: Setup disabled
--: Displayed when format is PAL (read only)
Q FILTER bandwidth setting
--: Displayed when format is PAL (read only)
SD RGB component signal Gch-SYNC or SD YCD
component signal Ych-SYNC on/off
WF signal SYNC on/off
23
Setup Menu