Table of Contents
Advertisement
Faults
Malfunction indicator lamp
lights up or flashes
The ABS warning lamp lights
up
High oil consumption
12-V battery discharged
Possible cause
Error in the electronic fuel
injection
The ABS fuse is blown
Large difference in wheel
speeds of the front and rear
wheels
Malfunction in ABS
The engine oil level is too high
The engine oil is too thin (low
viscosity)
The hazard warning flasher is
switched on
The 12-V battery is not being
charged by the alternator
The ignition was not switched
off while the vehicle was
parked
TROUBLESHOOTING 22
Action
–
Read out the fault memory using the
KTM diagnostics tool.
–
Change the fuses in the fuse box.
(
p. 264)
–
Stop the vehicle, switch off the igni-
tion, and start it again.
–
Read out the fault memory using the
KTM diagnostics tool.
–
Check the engine oil level. (
–
Change the engine oil and oil filter,
clean the oil screens.
(
–
Switch off the hazard warning flasher.
–
Charge 12-V battery.
(
–
Check charging voltage.
–
Charge 12-V battery.
(
p. 286)
p. 287)
p. 256)
p. 256)
309
Advertisement
Table of Contents
