Offset Reception - AOR AR-DV10 Operating Manual

・DMR COLOR
When set to ON, the receiver will only decode signals corresponding to the color code
number set in the DMR COL C column. There are 16 possible color codes, from 01 to 16.
Code 00 means that all color codes are decoded.
・P25 NAC
When set to ON, the receiver will only decode signals corresponding to the 3 digit
hexadecimal NAC code set in the P25 NAC C column.
Each digit can hold the value 0 to 9 or A to F. That makes 4096 possible NAC codes.
Code 000 means that all NAC codes are decoded.
・NXDN RAN
When set to ON, the receiver will only decode signals corresponding to the RAN code
number set in the NXDN RAN C column. There are 63 possible color codes, from 01 to 63.
Code 00 means that all RAN codes are decoded.
DIGITAL SIGNAL INFO DISPLAY
When using the D-STAR mode, by default the marked
dotted area is used to display some user information.
You can toggle this info display on or off as follows:
1. Long press on [MENU].
2. Use [▶] to select [DIGI DISP] and press [ENT]
3. Use [▶] to select either [DISP ON] or [DISP OFF]
and press [ENT]

10.8. OFFSET RECEPTION

AR-DV10 can be easily programmed to shift the receive frequency by a preprogrammed
value.
It is useful for receiving two-frequency radio communications, such as a base station and a
mobile station or a relay station, that transmit to each other on two frequencies.
The difference between the two frequencies is the offset
frequency.
Access the offset menu as follows:
1. Press [MENU] followed by [ENT].
2. Use [▶] to select [VFO EDIT] and press [ENT]
3. Use [▶] to select either [OFFSET F.] and press [ENT]
49