AOR AR-DV10 Operating Manual page 36

2. Use the [▶] button to select [GRP EDIT] and press [ENT] twice.
3. Enter the scan group number you would like to create, with the keypad.
This illustration shows an example of scan group 0 and
all bank numbers from 00 to 39 which can be linked,
providing of course they already have frequencies
registered.
4. Press the [▶] button followed by [ENT], that will select
the first bank 00 (the selected bank will blink).
Let's say we want to link banks 00 and 01.
5. Press the [ . ] key to register bank 00.
6. Use the [▶] button to go to bank 01 and press the [ . ]
key to register bank 01. (You can also rotate the dial
selector knob to rapidly scroll through the bank
numbers)
If you selected another bank number by mistake, you can
deselect it with the [.] key.
The linked banks 00 and 01 will appear as follows:
00 01 02 03 04 05 06 07 08 09
10 11 12 13 14 15 16 17 18 19
20 21 22 23 24 25 26 27 28 29
30 31 32 33 34 35 36 37 38 39
7. Press the [9] key to save the bank link selection and move to the following settings for
[DELAY TIME].
Delay time:
It's the time between signal interruption and squelch closing, for scan to resume.
It can be set between 0.1 and 10 seconds, in 0.1 second increments.
[OFF] is for no delay.
Default is 2 seconds.
Press [ENT] and rotate the dial selector knob to select the desired timing.
Validate with [ENT]. The following setting [FREE] is now selected.
Free time:
It's the time after which scan will resume, no matter if the signal was interrupted or not.
It can be set between 1 and 60 seconds.
[OFF] means scan will only resume after signal interruption, as set in "Delay time".
Default is [OFF].
8. Press [ENT] and rotate the dial selector knob to select the desired timing.
9. Validate with [ENT].
10. To save all settings of this group link page, press [ENT].
34