Collating Copies/Prints - Canon iR6570 Manual

Collating Copies/Prints

The Finisher modes can be selected to collate the outputs in various ways, either by pages or
copy/print sets. You can specify whether the printed sheets are output face up or face down.
IMPORTANT
The Finisher modes cannot be set if transparencies, tracing paper, or labels is selected.
3
NOTE
• For instructions on using the optional finishers, see Chapter 3, "Optional Equipment," in the Reference
Guide.
• To specify whether the printed sheets are output face up or face down, press [Face Up/Face Down] and
select from the following:
- [Auto]: If you copy a single page original, or copy on nonstandard sized paper or other available paper
loaded in the stack bypass, the printed sheets are output face up. Otherwise, the printed sheets are
output face down.
- [Face Down (Normal)]: Printed sheets are always output face down.
- Face Up (Reverse)]: Printed sheets are always output face up.
• If you set the Staple or Hole Punch mode, the side of the paper which is printed on will always be output
face down.
3-30

Collating Copies/Prints