Canon iR6570 Manual page 271

IMPORTANT
• If you are using the Margin and Two-sided modes together and copying or printing a document
that already has a margin, follow the instructions below:
- 1 2-Sided: Set the Margin mode for the back only.
- 2 2-Sided: You do not need to set the Margin mode. Proceed to make copies or prints in the
usual way.
- 2 1-Sided: Set the Margin mode for the back only.
• If you are using the Margin and Two-sided modes together and copying or printing a document
that already has a left or right margin, follow the instructions below:
- 1 2-Sided: Set the Margin mode for both the front and back.
- 2 2-Sided: Set the Margin mode for both the front and back.
- 2 1-Sided: Set the Margin mode for both the front and back.
NOTE
• The default setting is '10 mm'.
• If you enter a value other than 0, you can switch between positive and negative margin width by
pressing [±].
©
Example: (+)10 [±]
©
-50 [±]
• For instructions on entering values in inches, see Chapter 2, "Basic Operations," in the
Reference Guide.
©
-10
©
(+)50
Margin Mode 4-53
4